LATHAM OUTBOARD 10"
SPACER KITS are installed between
the lower gear case and the mid section
of your outboard motor. This converts
a 30" motor to a 35" allowing
the motor to be mounted higher on the
transom, keeping the motor power head
clear of any potential back splash. By removing
the stock 5" spacer and installing
the Latham 10" spacer kit, you can
make the conversion without the need to
stack spacers and performing costly shaft
extensions. Spacer kits are available
for the MERCURY VERADO® and
the YAMAHA 4 STROKE® outboard
motors and include the spacer, shaft,
all the studs, nuts, water tube extension,
shifter extension and the speedo extension
hose and fitting.
KPLT-7959
YAMAHA 4 STROKE®
10" SPACER
KIT
KPLT-7959 YAMAHA
4 STROKE® 10"
SPACER KIT designed
to lower the 225 and
250's propeller by 5"
without double stacking
stock spacers, allowing
the transom bracket
to be installed higher
than normal. The spacer
is installed between
the mid section and
the lower gear case
and is easy to install
as no machining is necessary.
Each Kit includes the
10" spacer, drive
shaft, water pickup
extension coupler, the
speedo extension hose
and fitting, the shifter
extension coupler and
all fasteners.
KEXT-8164
YAMAHA® F350
5" EXTENSION
KIT
YAMAHA®
F350 5" EXTENSION
KIT designed
to lower the 30"
F350 outboard
propeller by 5",
allowing the transom
bracket to be
installed higher
than normal. A
modified spacer
is installed between
the mid section
and the stock
5" spacer,
above the lower
gear case, and
is easy to install
as no machining
is necessary.
Each Kit includes
a modified 5"
spacer, drive
shaft, water pickup
extension coupler,
the pitot extension
hose and fitting,
the shifter extension
coupler and all
fasteners.
Mercury
Verado is a registered trademark
of the Brunswick Corporation. Yamaha
4 STROKE is a registered trademark
of the Yamaha Motor Corporation.
KPLT-7959 YAMAHA
4 STROKE® 10"
SPACER KIT designed
to lower the 225 and
250's propeller by 5"
without double stacking
stock spacers, allowing
the transom bracket
to be installed higher
than normal. The spacer
is installed between
the mid section and
the lower gear case
and is easy to install
as no machining is necessary.
Each Kit includes the
10" spacer, drive
shaft, water pickup
extension coupler, the
speedo extension hose
and fitting, the shifter
extension coupler and
all fasteners.
